I’m familiar to use dynamic routing and not static routing. All tutorials are with static routing where wireguard is included. First i tried to add the routing and then disable the routing in the same command. Like this: PostUp = ip route delete 192.168.5.0/24 dev wg0; ip route delete 192.168.6.0/24 dev wg0PostDown = sleep 2 Then i found a way to disable the complete manual routing with this syntax in the wireguard config file. Table = off Source.
Blog Posts
https://www.youtube.com/watch?v=emjoM-8zGdo
It looks like that after couple of days of testing wireguard through vyos and using BGP for dynamic routing, i have issue with some routes learned. Actually i discovered that this is a bug of vyos …
From time to time in my daily job i need very fast console access remotely to some network switches. This is not easy all the time.Digging around i found a solution using minicom as a linux …
Zerotier it was a great solution for all VPN locations until i found out the performance of Wireguard.Installation of Wireguard to Synology looks like was not that easy i was expected (just upload the app). After …
Topology First of all, let’s specify some internet links to make an idea of maximum throughput performance:Timisoara -> 1000 Mbps down / 500 Mbps upArad -> 90 Mbps down / 90 Mbps upDeva -> 1000 Mbps …
I asked myself how i can migrate SSD from the old one (120GB) to the new one (960GB) without vMotion and on a small ESXi 6.7 hardware. Found out to be pretty simple. Connect to ESXi …
Recent Comments